1.
~~~
SCL
-
1OA
2.
Chromatopac
9
-
6
Overview
Each unit of the RID
-
10A system has been inspected stringently at
the factory during the production process. The inspection procedures
described
m
this
manual
have
been
produced
by
compiling
and indicating
the inspection activities that are bothactually necessary and can be
practically executed by the user. That is, this
manual
is intended to
serve
as
a reference
book
for inspection procedures that do not
require specialized expensive equipment that is used at the factory
during
manufacture.
When inspection
results
obtained by the procedure
described in
this
manual meet the acceptance criteria, the
RID-
10A
can
be
used without problem.
Frequency for executing hardware validation
Roughly speaking, perform hardware validation every
6
to
12
month. Adjust the frequency of the inspection based on the actual
operating
conditions
of
the
LC system. When the
LC
unit is
operated
continuously,
day
and night, the intervals between inspections will
necessarily
be
shorter.
As
mentioned above, when the equipment is
judged to be improper, hardware validation must
be
executed
immediately to
comt any possible malfunctions.
3.
Validation item
With the
RID-IOA,
validation is performed
on
the following items.
Statement is made in reference to the regulation
in
the ASTM
(American Society
for
Testing and Materials) E1303
-
89.
(1)
(2)
Checking the lamp intensity
(3)
(4)
Checking the span
Checking the
lamp
lit time
Checking the temperature control system
4.
Validation procedure
Validation procedure differs depending on the system configuration
with which the
RID-1OA
is
used.
This
chapter describes the following
methods of validation.
I
Control
of
the
RID-1OA
I
Data
orocessina
unit
I
Paae
I
I
Stand
alone
I
Chromatopac
I
9-3
I
9
-
2
-
RID-1OA
To Next Page