Shimadzu UP2202X - Taring;Printing at Stability

57
10. Enhancing Productivity
2
4
1
3
5
6
7
11
13
12
8
9
10
14
10.6 Taring/Printing at Stability
Not applicable to a verified balance as a legal measuring instrument in using region
Determine if the balance should wait for stability before printing when the [PRINT] key is pressed or
zeroing when the [O/T] key is pressed. However, if the [PRINT] key is pressed while menu group 4
functions are being used, data will be output without waiting for detection of stability.
Instant operation setting Operates immediately when a key is pressed without waiting for detection of
stability.
Select menu item
39
Stability wait setting Operations after detection of stability. Select menu item
40
Notes
Operations when waiting for stability (while stability is not detected) are as
follows.
• When the [O/T] key has been pressed,
“---” is displayed. At this occasion, press the [POWER] key if you desire to
disable this function and abort taring.
• When the [POWER] key is pressed
The communication symbol and [STAND-BY] symbol will each be
displayed while waiting for detection of stability. Data will be output once
stability is detected. Even if the [PRINT] key is used to switch to the
standby state while stability is not detected, data will be output when
stability is detected for the next measurement.
• See 8.3 for details of stability detection.