9(108)
1. General Description
Read this manual carefully before operation to prevent damage of the
machine or personal injuries.
The STM series standard oil heater are used to heat up the mould and maintain
this temperature, although they can be used in other similar applications. High
temperature oil from the mould is returned to the cooling tank and cooled by
indirect cooling. It is then pressurised by the high-pressure pump, sent to the
heating tank and finally to the mould with a constant temperature. With our
optimised design, oil can reach a maximum of 200 and the ℃ HANYOUNG
temperature controller can maintain an accuracy of ±1℃.
Model: STM-910 Model: STM-910-D
To Next Page
Loading...
Need help?
General
