SICK Inspector PIM60 User Manual

Table B.25 Commands Ethernet Raw - device settings and actions examples
ACK messageCommand(s)Description
a
rsINT 120 0
raACT 5 0
sINT 120 192 168 1 110
aACT 5 0
b
Set device IP address
Apply IP settings
rsINT 121 0
raACT 5 0
sINT 121 255 255 255 0
aACT 5 0
b
Set device netmask
Apply IP settings
rsINT 122 0
raACT 5 0
sINT 122 192 168 1 1
aACT 5 0
b
Set device gateway (optional)
Apply IP settings
rsINT 20 0
raACT 3 0 75
c
sINT 20 1
aACT 3 6
Enter calibration mode
Perform calibration
a
The below examples can also be done by sending the set device IP address, set device netmask and set device
gateway in a sequence and then send the aACT 5 command to activate all these settings
b
The aACT 5 command will make the device being temporarily disconnected while the new settings are applied.
After this command the new IP address will have to be used in order to connect to the device
c
Returned value is the calibration target coverage in percent
8015726/2013-11
©SICK AG • Advanced Industrial Sensors • www.sick.com • All rights reserved
Subject to change without notice
76
Reference Manual
Command channel
Appendix
Inspector PIM

SICK Inspector PIM60 Specifications

General

Brand	SICK
Model	Inspector PIM60
Category	Accessories
Language	English