SICK RFU62 Series - Page 22

Product feature/func‐
tion
Characteristic
Data processing
•
Variable read data output based on event-dependent evaluation
conditions
•
Influencing the output string by filtering and output sorting
•
Implementation of application-specific data output protocols using
the SICK AppStudio development environment (flexible back-end
integration)
Data communication
•
Host interface: two configurable data output formats. Switchable to
different physical or logical interfaces. Parallel operation possible.
For outputting data to a further-processing computer.
•
Aux interface: fixed data output format. Switchable to different phys‐
ical or logical interfaces. For device configuration and diagnostics
as well as transponder access.
Electrical Interfaces
•
Host interface
°
RS-232, RS-422/485 (configurable data format and protocol),
CAN. These interfaces are not available for RFU62x-105xx (PoE
variant).
°
Ethernet (supported protocols include, amongst others,
PROFINET single port). This interface is not available for
RFU62x-104xx (serial variant)
•
Aux interface
°
RS-232 (fixed data format, data transmission rate and protocol).
This interface is not available for RFU62x-105xx (PoE variant).
°
Ethernet (interface is not available for RFU62x-104xx, serial vari‐
ant), USB
2)
•
CAN interface for integrating the device into the SICK-specific CAN-
SENSOR network. Interface not available for RFU62x-105xx.
•
2 digital switching inputs (interfaces not available for
RFU62x-105xx)
•
2 digital switching outputs (interfaces not available for
RFU62x-105xx)
•
Expandable with 2 software-controlled digital switching inputs and
outputs respectively via the CMC600 parameter cloning module
1)
in
the CDB
1)
or CDM
1)
connection module (function not available for
RFU62x-105xx)
Connectivity (Design)
•
RFU62x-101xx: 2 x M12 male circular connector, 1x USB (type
Micro-B)
•
RFU62x-104xx: 1 x cable with 15-pin D-Sub-HD male connector, 1x
USB (type Micro-B)
•
RFU62x-105xx: 1 x M12-male circular connector, 1 x USB (type
Micro-B)
1)
Optional accessories.
2)
Interface for temporary use only as a servicing interface.
3.2.5 Memory card
NOTE
The memory card is an optional accessory and is not included in the scope of delivery.
Functions
The device can execute the following functions on the plug-in microSD memory card:
•
Saving the parameter set (cloning function)
Semi-automatic, additional storage of the internal parameter set (device configura‐
tion data) on an external memory medium. This takes place in the framework of
the recommended backup concept for the 4Dpro device parameter sets.
3 PRODUCT DESCRIPTION
22
O P E R A T I N G I N S T R U C T I O N S | RFU62x 8015930/ZTM0/2018-11-06 | SICK
Subject to change without notice