Engineering and remote access
3.6 SITOP UPS Manager
SITOP UPS1600 / UPS1100
Manual, 04.2017, A5E37775406-8-76
133
1. Start the UPS Manager.
2. Using the menu command "Display > Operating data > Base unit" the firmware version of
the SITOP UPS1600 is displayed.
In the example shown, firmware version V2.0.1 is installed on the SITOP UPS1600.
The SITOP UPS1600 is reset while updating the firmware. For safety reasons, the output is
switched off.
Ensure that no damage is caused to the plant or system.
Ensure that the PG/PC and/or all switches, routers and gateways that are used have an
independent power supply during the firmware update.
To Next Page
Loading...
