To Next Page

To Previous Page

List of Parameters

Parameters

1-451

SINAMICS G120 Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011

Description: Display parameter for binary quantity QU of instance NCM 1 of the numeric comparator.

QU is only set if X0 > X1.

Description: Display parameter for binary quantity QE of instance NCM 1 of the numeric comparator.

QE is only set if X0 = X1.

Description: Display parameter for binary quantity QL of instance NCM 1 of the numeric comparator.

QL is only set if X0 < X1.

Description: Setting parameter for the run-time group in which the instance NCM 1 of the numeric comparator is to be called.

Value: 5: Run-time group 5

6: Run-time group 6

9999: Do not calculate

Description: Setting parameter for the run sequence of instance NCM 1 within the run-time group set in p20322.

Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run

sequence value.

r20319 BO: NCM 1 output QU / NCM 1 output QU

Access level: 3 Calculated: - Data type: Unsigned32

Can be changed: - Scaling: - Data set: -