Siemens CU240B-2 - 1.5 Quick commissioning (p0010 = 1)

Quick commissioning (p0010 = 1)
Parameters
1-485
© Siemens AG 2011 All Rights Reserved
SINAMICS G120 Control Units CU240B/E-2 Parameter Manual (LH11), 01/2011
1.5 Quick commissioning (p0010 = 1)
The following parameters are necessary for quick commissioning (p0010 = 1).
.
Table 1-7 Quick commissioning (p0010 = 1)
Par.-No. Name Access level Can be
changed
p0010 Drive commissioning parameter filter 1 C(1)T
p0015 Macro drive unit 1 C,C(1)
p0100 IEC/NEMA mot stds 1 C(1)
p0205 Power unit application 1 C(1,2)
p0230 Drive filter type, motor side 1 C(1,2)
p0300 Motor type selection 2 C(1,3)
p0301 Motor code number selection 2 C(1,3)
p0304 Rated motor voltage 1 C(1,3)
p0305 Rated motor current 1 C(1,3)
p0307 Rated motor power 2 C(1,3)
p0308 Rated motor power factor 1 C(1,3)
p0309 Rated motor efficiency 1 C(1,3)
p0310 Rated motor frequency 1 C(1,3)
p0311 Rated motor speed 1 C(1,3)
p0314 Motor pole pair number 1 C(1,3)
p0316 Motor torque constant 3 C(1,3)
p0322 Maximum motor speed 3 C(1,3)UT
p0323 Maximum motor current 1 C(1,3)
p0335 Motor cooling type 1 C(1,3)
p0500 Technology application PM230: 4
PM240: 2
C(1,3)T
p0640 Current limit 2 C(1,5)T
p0700 Command source selection 1 C(1,3)UT
p0922 PROFIdrive telegram selection 1 C(1)T
p0970 Reset drive parameters 1 C(1,30)
p1000 Selecting the speed setpoint 1 C(1)T