Siemens CU240S PN-F - Page 104

Functions
5.5 Changing over the command data sets (manual, automatic)
CU240S and CU240E Control Units, FW 3.2
104 Operating Instructions, 03/2009, A5E02440075B AA
,QYHUWHUFRQWURO
&RPPDQGVRXUFHV
6HWSRLQWFDOFXODWLRQ
3URWHFWLRQ
IXQFWLRQV
6WDWXVPHVVDJHV
)DLOVDIHIXQFWLRQV
)DLOVDIHFRP
PDQGVRXUFHV
0RWRUFRQWURO
6HWSRLQWVRXUFHV
7HFKQRORJLFDO
IXQFWLRQV
 'LJLWDOLQSXWV
 2SHUDWRUSDQHO
 )LHOGEXV
 $QDORJLQSXWV
 )L[HGVHWSRLQWV
 0RWRUL]HG
SRWHQWLRPHWHU
 -2*VHWSRLQW
)LHOGEXV
 )LHOGEXV
 'LJLWDORXWSXWV
Figure 5-7 CDS switchover in the inverter
The command data sets are switched over using parameters P0810 and P0811. Parameters
P0810 and P0811 are interlinked to control commands, e.g. the digital inputs of the inverter,
using BICO technology.