Commissioning
4.5 Commissioning with STARTER
CU240S and CU240E Control Units, FW 3.2
70 Operating Instructions, 03/2009, A5E02440075B AA
4.5.4 Commissioning the application
Description
● You can now commission your application using the "Drive Navigator" screens or by
using the functions available in the project tree.
● Save your settings so that they are protected against power failure (see below).
● Once you have commissioned your application, disconnect the online connection
between the PC and inverter by clicking on
.
Figure 4-16 Application communication
Storing data in a power-independent manner
● In the project tree, select your SINAMICS project
● Double-click on "Drive Navigator".
● Select "Commissioning" in the working area
● In the dialog box, select "Save data in the drive (RAM to ROM)".
You can now disconnect the online connection with
"Disconnect from target system"
To Next Page
Loading...
