Siemens CU240S PN-F - Table of Contents

CU240S and CU240E Control Units, FW 3.2
Operating Instructions, 03/2009, A5E02440075B AA
5
Table of contents
1 Introduction................................................................................................................................................ 9
1.1 About this manual ..........................................................................................................................9
1.2 Fast track commissioning ............................................................................................................10
1.3 Adapting inverters to the application (parameterization for entry level personnel)......................11
1.3.1 General basics .............................................................................................................................11
1.3.2 Parameter ....................................................................................................................................12
1.3.3 Parameters with follow-on parameterization................................................................................13
1.4 Frequently required parameters...................................................................................................14
1.5 Extended adaptation options (parameterization for advanced level personnel)..........................16
1.5.1 BICO technology: basic principles ...............................................................................................16
1.5.2 BICO technology: example ..........................................................................................................19
2 Description............................................................................................................................................... 21
2.1 Modularity of the converter system..............................................................................................21
2.2 Overview of Control Units ............................................................................................................23
2.3 Overview of Power Modules ........................................................................................................24
2.4 Reactors and filters ......................................................................................................................25
3 Connection .............................................................................................................................................. 27
3.1 Procedure for installing the frequency inverter ............................................................................27
3.2 Mounting reactors and filters........................................................................................................28
3.3 Mounting Power Modules ............................................................................................................30
3.3.1 Dimensions, hole drilling templates, minimum clearances, tightening torques ...........................31
3.3.2 Wiring Power Modules .................................................................................................................36
3.3.3 EMC-compliant connection ..........................................................................................................39
3.4 Installing the Control Unit.............................................................................................................41
3.4.1 Interfaces, connectors, switches, control terminals, LEDs on the CU.........................................42
4 Commissioning ........................................................................................................................................ 45
4.1 Initial coupling of the CU and PM - message F0395 ...................................................................46
4.2 Restoring the factory settings ......................................................................................................
47
4.3 Preparing commissioning.............................................................................................................48
4.4 Commissioning with factory settings............................................................................................51
4.4.1 Wiring examples for the factory settings......................................................................................52
4.4.2 Factory setting of the frequency inverter .....................................................................................54
4.4.3 Default terminal settings ..............................................................................................................56
4.5 Commissioning with STARTER ...................................................................................................58
4.5.1 Creating a STARTER project.......................................................................................................59
4.5.2 Establishing an online connection between the PC and converter (going "online") ....................64
4.5.3 Starting the general commissioning.............................................................................................65
4.5.4 Commissioning the application ....................................................................................................70