Technical Description, Installation Instructions, Operation
41
DP/AS-Interface Link 20E
Release 11/2002
C79000-G8976-C138–04
Configuring Analog Slaves as Standard Slaves
If you want to configure analog slaves you should also use the AS-i standard slave.
You set the properties of the analog interface using the combination of the I/O
configuration and the three ID codes. Please refer to the manual of the AS-i slave
you are using for information about the parameter settings.
These parameters are specified in compliance with the DP standard V1.
Example:
General I/O configuration for analog
slaves.
ID codes for analog slaves that can
be found in the relevant manual.
Here, for example:
S ID Code: 3h
S ID1: Fh (is not evaluated)1
S ID2: 5h = 2-channel analog slave
1 For AS-i slaves that do not support the ID1/ID2
codes, enter the values F
H
.
To Next Page
Loading...
