EasyManua.ls Logo

Siemens DP/AS-Interface Link 20E

Siemens DP/AS-Interface Link 20E
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Using the Command Interface
76
DP/AS-Interface Link 20E
Release 11/2002
C79000-G8976-C138–04
Table 3-5 Error Coding, continued
DONE MeaningSTATUSERROR
0 1 83A3H An AS-i slave with the new address already exists on the
AS-Interface.
0 1 83A4H The AS-i slave address cannot be deleted.
0 1 83A5H The AS-i slave address cannot be set.
0 1 83A6H The AS-i slave address cannot be stored permanently.
0 1 83A7H Error reading the extended ID1 code.
0 1 83A8H The target address is not plausible (for example a B slave
address was used for a standard slave).
0 1 83B1H A length error has occurred transferring a string according
to profile 7.4.
0 1 83B2H A protocol error has occurred transferring a string
according to profile 7.4.
0 1 83F8H The job number or the job parameter is unknown.
0 1 83F9H The AS-i master has detected an EEPROM error.
0 1 8F22H Area length area reading a parameter
8F23H Area length error writing a parameter
This error code indicates that a parameter is entirely or
partly outside the address area or that the length of a bit
array of an ANY parameter cannot be divided by 8.
0 1 8F24H Area error reading a parameter
8F25H Area error writing a parameter
This error codes indicates that a parameter is located in an
area that is illegal for a system function.
0 1 8F28H Alignment error reading a parameter
8F29H Alignment error writing a parameter
This error code indicates that the reference to a parameter
is a bit address other than 0.
0 1 8F30H The parameter is in the write-protected global DB
8F31H The parameter is in the write-protected instance DB
This error code indicates that a parameter is located in a
write-protected data block.
0 1 8F32H The DB number in the parameter is too high
0 1 8F3AH The parameter contains the number of a DB that is not
loaded
0 1 8F42H An access error has occurred while the system attempted
to read out a parameter from the peripheral area of the
inputs.
0 1 8F43H An access error occurred while the system was attempting
to write a parameter to the peripheral area of the outputs

Table of Contents

Related product manuals