38
Smart Infrastructure A6V10393190_h_en_--
2019-09-01
5.3 LED indication
The following LED indications are available:
No. Description Colour Status Function
1 Alarm Red ON The fire control panel is in 'Alarm' condition.
2 Acknowledge Yellow Slow Indicates where action is expected.
3 More alarm Red Slow More than two zones have triggered a fire alarm.
4 Reset Yellow Slow Indicates the action in case of an alarm or fault.
5 Fire brigade Red ON Depending on the programming mode.
Option 1: Call the fire brigade, panel is in alarm mode.
Option 2: Call the fire brigade, output Alarm dialer is active.
Option 3: Fire brigade is called.
6 System on Green ON The system is in operation.
7 General fault Yellow ON Indicates any fault in the system.
8 System fault Yellow ON Indicates CPU failure.
9 Sounder fault Yellow ON Sounder lines are disabled.
Slow Sounder line is in fault state.
10 Alarm dialer fault Yellow ON Alarm dialer output is disabled.
Slow Alarm dialer output is in fault state.
11 Test condition Yellow ON At least one zone is in test state.
12 Isolation Yellow ON At least one zone or output is disabled.
13 Manned / Unmanned Yellow ON Manned operation (AVC).
OFF Unmanned operation (AVC).
Fast 2 Hz Reaction time V1 is running (AVC).
Slow 1 Hz Investigation time V2 is running (AVC).
14 Resound Red ON Sounder lines are activated.
15 Silence Yellow ON Sounder lines are silenced.
11 12
q
2
3
4
13 14 15
7
8
5
6
9 10
1
To Next Page
Loading...
