Siemens Hicom 300 H - Using Call Forwarding (Hipath 4000)

Forwarding calls
73
7373
73
Step by Step
Using call forwarding (HiPath 4000)
You can program two types of call forwarding:
• Station fixed forwarding*, and
• station variable forwarding
With station fixed forwarding you can program a for-
warding destination that will remain valid until you
change or delete it. This forwarding function can be
switched on and off.
With station variable forwarding you can choose be-
tween 6 different types of forwarding:
• Station variable unconditional/all forwarding
– forwarding for internal calls only
– forwarding for external calls only
– forwarding for both internal and external calls
• Forwarding for busy (int/ext)
• Forwarding after no answer (int/ext)
• Forwarding for busy and ring no answer
Call forwarding is activated when a forwarding destina-
tion is programmed. When the station variable forward-
ing function is switched off, the forwarding destination
is automatically deleted.
When forwarding is activated you can see the following
display in the idle menu:
See Æ page 80 or Æ page 81 to find out how to acti-
vate/de-activate call forwarding via codes or an installed
forwarding key.
* Station fixed forwarding is optional
Forwarding type Display message
Station fixed forwarding
Station variable forward-
ing
Forwarding to e.g. 222 Klaus
Meier (own number)
Forwarding for internal/
external calls only
Forwarding for internal/exter-
nal On
Forwarding for busy Forwarding on busy On
Forwarding after time Forwarding on timeout On
Forwarding for busy and
ring no answer
Forwarding on busy or time-
out On
Station fixed forwarding Fixed forwarding On