Getting to know your OpenStage phone
20
Programmable sensor keys
Your OpenStage 40/40 G has six illuminated sensor keys. You can assign
functions and phone numbers to them on two levels.
Depending on how they are programmed, you can use the sensor keys as:
• Function keys Æ page 68
•Repdial keys Æ page 73
•Procedure keys Æ page 71
Touch the key to activate the programmed function or dial the stored num-
ber.
Press the key to open a menu for programming it Æ page 71.
A label for the function is displayed to the left of the key; it cannot be
changed. You can define the labeling for repdial or DSS keys according to
your requirements Æ page 74.
The status of a function is shown by the LED on the corresponding sensor
key.
Meaning of LED displays on function keys and DSS keys
Increase the number of programmable sensor keys by connecting a
key module Æ page 16.
You can program all programmable sensor keys (except "Shift") on
two levels. The Shift key Æ page 68 must be configured for this,
and extended key functionality must be active (contact your service
personnel).
In addition to functions and procedures, external phone numbers
and internal numbers without LED display can also be saved on the
second level Æ page 73.
LED Meaning of function key Meaning of DSS key
S
Off The function is deactivated. The line is free.
T
Flashing
[1]
[1] In this manual, flashing sensor keys are identified by this icon, regardless of the flashing in-
terval. The flashing interval represents different statuses, which are described in detail in
the corresponding sections of the manual.
The function is in use. The line is busy.
R
On The function is activated. There is a call on the line.
The programmable sensor keys on multi-line phones function as
trunk keys Æ page 100.
Mirea, Ch
Layer 1
To Next Page
Loading...
