Siemens HiPath OpenOffice - Using System Functions from Outside DISA (Direct Inward System Access)

More functions/services
93
Step by Step
Using system functions from outside
DISA (direct inward system access)
If configured (contact your service personnel), you can
use an external phone like an internal station to set up
an outgoing external connection via the system. You
can also activate or deactivate the following system
functions:
• Reset services and functions,
code #0 Æ page 91
• Call forwarding, code
*
1/#1 Æ page 38
• Lock and unlock phone,
code
*
66/#66 Æ page 82
• Save your PIN,
code
*
93 Æ page 84
• Send a message,
code
*
68/#68 Æ page 86
• Leave an advisory message,
code
*
69/#69 Æ page 88
• Ringing group, code
*
81/#81 Æ page 108
• Group call, code
*
85/#85 Æ page 108
• Caller ID suppression,
code
*
86/#86 Æ page 80
• Camp-on tone, code
*
87/#87 Æ page 58
• Open door, code
*
61 Æ page 46
• Release door opener, code
*
89/#89 Æ page 47
• Control relays, code
*
90/#90 Æ page 97
• Do not disturb, code
*
97/#97 Æ page 79
• Ringer cutoff, code
*
98/#98 Æ page 79
• Dial using speed dial, code
*
7 Æ page 53
• Associated service, code
*
83 Æ page 92
Prerequisite: Your phone supports tone dialing (DTMF)
or you can switch your phone to tone dialing. The phone
is not connected to the system.
j Establish a connection to the system. Enter the station
number (contact your service personnel).
j Wait for the continuous tone (if necessary, switch
phone to tone dialing) and enter the internal number as-
signed to you and the corresponding PIN.
( Enter the code (only required if programmed in the sys-
tem).