Step by Step
Basic functions
30
Basic functions
Answering a call
Your OpenStage phone rings with the tone signal set
when an incoming call is received. The call is also visu-
ally signaled on the call display.
• When you receive an internal call, your telephone
rings once every four seconds (single-tone se-
quence).
• When you receive an external call, your telephone
rings twice in rapid succession every four seconds
(dual-tone sequence).
• When you receive a call from the entrance tele-
phone, your telephone rings three times in rapid
succession every four seconds (triple-tone se-
quence).
• If a call is waiting, you hear a short tone (beep) every
six seconds.
If transmitted, calling party information (name, phone
number) appears on the graphic display.
Answering a call via the handset
The phone is ringing. The caller appears on the screen.
Pay attention to the notes on voice encryption
Æ page 78.
^ Lift the handset.
if nec.
+ or - Set the call volume. Keep pressing the key until the de-
sired volume is set.
Please read the introductory chapter "Getting to
know your OpenStage phone" Æ page 13 care-
fully before performing any of the steps de-
scribed here on your phone.
Your service personnel can adjust the ring ca-
dence for external and internal calls for you.
In other words, different ring cadences can be
set for different internal callers.
An incoming call will interrupt any ongoing tele-
phone setting operations.
To Next Page
Loading...
