Technical Instructions LMV Series
Document No. LV5-100
0
Section 9 Page 4 SCC Inc.
5. After the connection at the user level is successful, disconnect from the AZL5 and then
reconnect at the service or OEM level,
if desired. This is done by going to the “System LMV5x”
dropdown menu and selecting “Disconnect”. Remember that a password will be necessary to
access the LMV5 on the service or OEM level and that the password is case-sensitive.
Note: If a fault window appears, it is not necessary to close the fault window. It can be moved
to the side and temporarily ignored. Most tasks can be performed with the fault window open.
If the fault window is closed and the fault is not cleared, the fault window will reappear in a few
seconds.
To Next Page
Loading...
