LMV Series Technical Instructions
LV5-1000
SCC Inc. Page 4 Section 3
A I P
Actuators Ignition Position (see Ratio Control Curve) Password Updating 45
activation 20 Ignition Timings 8 PID (see Load Controller)
addressing 37 Inputs / Outputs (120 VAC) Prepurge / Postpurge 7-9
direction of rotation 37 air pressure switch 12 Program Stop 19, 21
potentiometer
44 burner switch 13 PTFI (see Ignition Timings)
ramp speed 21 fan aux contactor 12 R
Alarm high fuel pressure 13 Ratio Control Curve
configuration 9-10 low fuel pressure 13 curve points 19
silence 5 proof of closure 12, 16 ignition positions 18
Analog Output 34-35 L postpurge positions 18
B Load Controller prepurge positions 18
Backup / Restore 46 cold start (thermal shock) 31-32 start point 20
Burner ID 6, 45 configuration 33-34, 43 Repetition Counter 16
C on / off limits 30-31 S
Clock PID 29, 35 Setpoint 5, 30
daylight savings 36 Load Limits 5, 19-20 Software Version
set 5 Lockout History 5 AZL 37
Cold Start (see Load Controller) M burner control (LMV) 17
Computer Interface
6 Manual Operation 7, 21 load controller 35
F Modbus O
trim module 42
Fault History 5 activate / deactivate 6 VSD 40
FGR Special Functions 42-43 configuration 36 T
Flame Detector 14-16 MTFI (see Ignition Timings) Temp Limiter 31, 43
Fuel Meter O Thermal Shock (see Load Controller)
configuration 39 O2 Trim U
read 6, 45 commissioning 22-27 Updating AZL Software 46
reset 6, 45 configuration 40-41 V
Fuel Trains 11 data 6, 28, 41 Valve Proving 16-17
reactivate 7 Variable Speed Drive
Operating Hours 6, 44 configuration 39
Output (see Inputs / Outputs) data 40
To Next Page
Loading...
Need help?
General
