Siemens MAMMOMAT Novation DR - Installation of Biopsy Controller Holders

Installation 5 - 3
Siemens AG SPB7-230.814.01 Page 3 of 24 Opdima
Medical Solutions Rev. 01 10.04 CS PS 24 Installation
Installation of biopsy controller holders 5
The biopsy controller is attached to the rear cover of the stand. To install the holders
proceed as follows:
1. Install the three holders (2/Fig. 2) by using the nuts (3/Fig. 2).
2. Install the two standoffs (4/Fig. 2) by using the screws (5/Fig. 2) and the washers
(6/Fig. 2).
UP
OPD00267
985 – 5 mm
3
4
5
2
1
A
B
6
Fig. 2 Rear cover, from the back side