Siemens MAMMOMAT Novation DR - Installation of Opdima Printer (Option)

Opdima SPB7-230.814.01 Page 22 of 24 Siemens AG
Installation Rev. 01 10.04 CS PS 24 Medical Solutions
5 - 22 Installation
Installation of Opdima printer (option) 5
Stand alone Opdima system:
When the Opdima system is stand alone (not connected to a network) it is possible to
install a Codonics NP-1660 or NP-1600 printer to Opdimar as a stand alone printer
connected to the network connector.
The following equipment is needed:
• Codonics printer NP-1660 or NP-1600
• Crossover network cable
Proceed as follows to install the printer:
1. Connect one end of the network cable to the workstation (2C/Fig. 17).
2. Connect the other end of the network cable to the printer.
3. Connect the mains cable of the printer to the wall socket marked with label,
see Fig. 15.
4. Set the printer IP address to 10.10.10.2 see the User’s Manual for the Codonics
NP-1660 or NP-1600.
5. Select Scaled in printer setup in the advanced service dialog, see Stand alone
Opdima system in MAMMOMAT 1000/3000/3000 Nova - Opdimar Service
Instructions.
Networked Opdima system:
When the Opdimar system is networked it is possible to configure the system to print to a
printer connected to the network or a local postscript printer connected to the parallel
interface of the workstation.
It is also possible to connect a stand alone postscript printer to
the parallel or network connector of the workstation, see Use of
printer setup in MAMMOMAT 1000/3000/3000 Nova - Opdimar
Service Instructions.
The printer must be grounded to the same potential as the
MAMMOMAT.
Connect the printer power supply to the same branch circuit as
the MAMMOMAT power supply.
It is also possible to connect a stand alone postscript printer to
the parallel connector of the workstation, see Select printer in
MAMMOMAT 1000/3000/3000 Nova - Opdimar Service
Instructions.
NOTE
CAUTION
NOTE