Siemens MCP 398C Operation/Programming

3
08/2005 Machining the Workpiece
3.5 Startin
g
the machinin
g
at a s
p
ecific
p
oint in the
p
ro
g
ram
3
♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition 3-101
Cycle Start
 Press the "Cycle Start" key.
ShopTurn carries out all necessary pre-settings.
Cycle Start
 Press the "Cycle Start" key again.
The new starting position is approached. The workpiece is then
machined from the beginning of the target block.
Reset
You can abort the search by pressing the "Reset" key.

Siemens MCP 398C Specifications

General

Brand	Siemens
Model	MCP 398C
Category	Control Systems
Language	English