8
Tool Management 08/2005
8.10 Mana
in
ma
azine locations
8
♥ Siemens AG, 2005. All rights reserved
8-372 SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
8.10 Managing magazine locations
If a magazine location is defective, or when an oversize tool requires
more than half a neighboring location, you can disable the magazine
location.
It is no longer possible to assign any tool data to a disabled magazine
location.
In the "Tool condition" columns, you can also read whether a tool is
disabled (G) or over-sized (U).
You can change the tool conditions in the tool wear list (see Sec.
"Activating tool monitoring").
Disabling a magazine
location
Select the "Magazine" softkey in the "Tools WOs" operating area.
Place the cursor on the relevant empty magazine location in the
"Location disable" column.
Press the "Alternat.” softkey.
The letter "G" appears as a symbol for the disabling of the location.
Enable magazine
location
Select the "Magazine" softkey in the "Tools WOs" operating area.
Place the cursor on an empty magazine location in the "Location
disable" column.
Press the "Alternat.” softkey.
The letter "G" is no longer visible and the magazine location is now
free again.
To Next Page
Loading...
Need help?
General
