4
Creating a ShopTurn Program 08/2005
4
♥ Siemens AG, 2005. All rights reserved
4-148 SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
4.3.5 Program editor
You use the program editor when you want to change the sequence of
program blocks within a program, delete program blocks or copy
program blocks from one program to another.
The following functions are available in the program editor:
Select
You can select several program blocks simultaneously, for
example, for cutting and pasting them subsequently.
Copy/paste
You can copy and paste program blocks within a program or
between different programs.
Cut
You can cut and therefore delete program blocks. However, the
program blocks remain in the buffer, so you can still paste them in
somewhere else.
Search
You can search for a specific block number or any character string
in a program.
Rename
You can rename a contour in the program editor, e.g. if you have
copied the contour.
Numbering
When you insert a new or copied program block between two
existing program blocks, ShopTurn automatically assigns a new
block number. This block number may be higher than the one in
the following block. With the "Numbering" function, you can
renumber the program blocks in ascending order.
To Next Page
Loading...
Need help?
General
