4
Creating a ShopTurn Program 08/2005
4
♥ Siemens AG, 2005. All rights reserved
4-146 SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
îš¾ Position the cursor in the work plan on the line behind which a
new program block is to be inserted.
...
îš¾ Using the softkeys, select the desired function (see following
section).
The corresponding parameter screen form is displayed.
îš¾ Enter the values for the individual parameters.
îš¾ Press the "Help" key if you want to see the help screen, which
explains the individual parameters.
Tools
îš¾ Press the "Tools" softkey if you want to select a tool from the tool
list for parameter "T".
-and-
îš¾ Place the cursor on the tool that you want to use for machining.
-and-
To
Program
îš¾ Press the "To Program" softkey.
The selected tool is accepted into the parameter screen form.
îš¾ Press the "Accept" softkey.
The values are stored and the parameter screen form closes. The
work plan is displayed and the newly created program block is
highlighted.
To Next Page
Loading...
Need help?
General
