2
Setting Up the Machine 08/2005
2.10 Run times
2
♥ Siemens AG, 2005. All rights reserved
2-88 SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition
Load
The system calculates the actual machine utilization from the timed
machining time and the current machine run time.
The ratio of machining time to machine run time is displayed as a
percentage.
A setting in the machine data determines which run times are
displayed.
Please also refer to the machine manufacturer's instructions.
Jog
-or-
îš¾ Select "Machine Manual" or "Machine Auto" mode.
Run times
îš¾ Press the "Run times" softkey.
The T,F,S display window turns into the "Run times" window.
Pressing the "Run times" softkey again, takes you back to the T,F,S
display window.
îš„
To Next Page
Loading...
Need help?
General
