Siemens MD-BMS - Comms Setup (Communications Setup); RS-485 Settings; Bacnet Device Settings

Prepping for Installation
Comms Setup (Communications Setup)
35
Building Technologies 125-202
06/06/2017
Comms Setup (Communications Setup)
Use this tab to change communication parameters for the meter, such as
communication protocols and how those communications are transferred. This screen
displays the fields pertinent to your power connection and communication protocol, so
if you are connected by RS-485 then only those fields are shown. However, if you are
connected with a USB cable all fields are displayed. Changes to these fields override
any settings on the Communications tab.
RS-485 Settings
Change the Data Bits or Baud Rate on the meter by using these fields.
BACnet Device Settings