5 System Parameters Issue 03/01
MICROMASTER 411 & COMBIMASTER 411 Operating Instructions
74
6SE6400-5CA00-0BP0
ParNr ParText Default Acc WS QC
P1060[1] JOG ramp-up time 10.00 2 CUT N
P1061[1] JOG ramp-down time 10.00 2 CUT N
P1070[1] CI: Main setpoint 755:0 3 CT N
P1071[1] CI: Main setpoint scaling 1:0 3 CT N
P1075[1] CI: Additional setpoint 755:1 3 CT N
P1076[1] CI: Additional setpoint scaling 1:0 3 CT N
r1078 CO: Total frequency setpoint - 3 - -
r1079 CO: Selected frequency setpoint - 3 - -
P1080[1] Min. frequency 0.00 1 CUT Q
P1082[1] Max. frequency 50.00 1 CT Q
P1091[1] Skip frequency 1 0.00 3 CUT N
P1092[1] Skip frequency 2 0.00 3 CUT N
P1093[1] Skip frequency 3 0.00 3 CUT N
P1094[1] Skip frequency 4 0.00 3 CUT N
P1101[1] Skip frequency bandwidth 2.00 3 CUT N
r1114 CO: Freq. setp. after dir. ctrl. - 3 - -
r1119 CO: Freq. setpoint before RFG - 3 - -
P1120[1] Ramp-up time 10.00 1 CUT Q
P1121[1] Ramp-down time 10.00 1 CUT Q
P1130[1] Ramp-up initial rounding time 0.00 2 CUT N
P1131[1] Ramp-up final rounding time 0.00 2 CUT N
P1132[1] Ramp-down initial rounding time 0.00 2 CUT N
P1133[1] Ramp-down final rounding time 0.00 2 CUT N
P1134[1] Rounding type 0 2 CUT N
P1135[1] OFF3 ramp-down time 5.00 2 CUT Q
r1170 CO: Frequency setpoint after RFG - 3 - -
Drive Features (P0004 = 12)
ParNr ParText Default Acc WS QC
P0005[1] Display selection 21 2 CUT N
P0006 Display mode 2 3 CUT N
P0007 Backlight delay time 0 3 CUT N
P0011 Lock for user defined parameter 0 3 CUT N
P0012 Key for user defined parameter 0 3 CUT N
P0013[20] User defined parameter 0 3 CUT N
P1200 Flying start 0 2 CUT N
P1202[1] Motor-current: Flying start 100 3 CUT N
P1203[1] Search rate: Flying start 100 3 CUT N
P1210 Automatic restart 1 2 CUT N
P1211 Number of restart attempts 3 3 CUT N
P1215 Holding brake enable 0 2 T N
P1216 Holding brake release delay 1.0 2 T N
P1217 Holding time after ramp down 1.0 2 T N
P1232[1] DC braking current 100 2 CUT N
P1233[1] Duration of DC braking 0 2 CUT N
To Next Page
Loading...
