Siemens MICROMASTER 411 - Page 75

Issue 03/01 5 System Parameters
MICROMASTER 411 & COMBIMASTER 411 Operating Instructions
6SE6400-5CA00-0BP0
75
ParNr ParText Default Acc WS QC
P1236[1] Compound braking current 0 2 CUT N
P1240[1] Configuration of Vdc controller 1 3 CT N
r1242 CO: Switch-on level of Vdc-max - 3 - -
P1243[1] Dynamic factor of Vdc-max 100 3 CUT N
P1253[1] Vdc-controller output limitation 10.00 3 CUT N
P1254 Auto detect Vdc switch-on levels 1 3 CT N
Motor Control (P0004 = 13)
ParNr ParText Default Acc WS QC
r0020 CO: Freq. setpoint before RFG - 3 - -
r0021 CO: Act. frequency - 2 - -
r0022 Act. filtered rotor speed - 3 - -
r0024 CO: Act. output frequency - 3 - -
r0025 CO: Act. output voltage - 2 - -
r0027 CO: Act. output current - 2 - -
r0056 CO/BO: Status of motor control - 3 - -
r0057 Jumper status - 2 - -
r0067 CO: Act. output current limit - 3 - -
r0071 CO: Max. output voltage - 3 - -
r0078 CO: Act. current Isq - 3 - -
r0086 CO: Act. active current - 3 - -
P1300[1] Control mode 0 2 CT Q
P1310[1] Continuous boost 50.0 2 CUT N
P1311[1] Acceleration boost 0.0 2 CUT N
P1312[1] Starting boost 0.0 2 CUT N
P1316[1] Boost end frequency 20.0 3 CUT N
P1320[1] Programmable V/f freq. coord. 1 0.00 3 CT N
P1321[1] Programmable V/f volt. coord. 1 0.0 3 CUT N
P1322[1] Programmable V/f freq. coord. 2 0.00 3 CT N
P1323[1] Programmable V/f volt. coord. 2 0.0 3 CUT N
P1324[1] Programmable V/f freq. coord. 3 0.00 3 CT N
P1325[1] Programmable V/f volt. coord. 3 0.0 3 CUT N
P1333[1] Start frequency for FCC 10.0 3 CUT N
P1335[1] Slip compensation 0.0 2 CUT N
P1336[1] Slip limit 250 2 CUT N
r1337 CO: V/f slip frequency - 3 - -
P1338[1] Resonance damping gain V/f 0.00 3 CUT N
P1340[1] Imax controller prop. gain 0.000 3 CUT N
P1341[1] Imax controller integral time 0.300 3 CUT N
r1343 CO: Imax controller freq. output - 3 - -
r1344 CO: Imax controller volt. output - 3 - -
P1350[1] Voltage soft start 0 3 CUT N