Appendix
A.2 Appendix II
BW500 and BW500/L
Operating Instructions, 12/2016, A5E33482052-AD
201
2.02 October 08, 1999
• Limited external contact
closure to 300 msec
• Added software filter to
speed signal
• Factoring now based on
current zero value
•
Individual damping added for
Rate, Load and Speed dis-
play
• Parameters saved perma-
nently in Flash
• German added
• Devicenet added
• Display only the load cells
selected
2.03 May 16, 2000
• Allow proper startup if no
RAM battery installed
2.04 June 30, 2000
• Larger flash added
2.05 February 07, 2001
• SmartLinx update time in-
creased to 250 msec.
• Batch totalizer was made
accessible using Modbus
• New real time clock added
• BW500 calibrations no long-
er affected by time out
• Auto Zero alarm relay will
now reset toggling from pro-
gram to run mode
2.06 February 17, 2001
• Updated calibration error so
that it will not display a nega-
tive 0 error, -0.00%
3.00 April 27, 2001
• Added flowmeter option
• Parameters are no longer
changeable with remote
communications when certi-
fication switch set
To Next Page
