Siemens MOBILETT Plus - Page 69

Miscellaneous 8 - 5
Siemens-Elema AB SPR8-215.898.01 Page 5 of 6 MOBILETT Plus/ - E/ - M
Solna, Sweden Rev. 05 01.02 SPS-UD
• Clean cable winder box.
• Remove plug, cable stop and ring (pos. 4 / Fig. 4).
If cable winder has to be replaced:
• go to "B".
If mains cable has to be replaced:
• Remove four screws (pos. 3 / Fig. 5).
• Remove connection plate and disconnect the mains cable (pos. 1 / Fig. 6).
• Install new mains cable and connection plate.
"B"
• Reinstall ring, cable stop and plug.
• Reinstall cable winder.
• Reinstall the securing screw (pos. 1 / Fig. 7).
Fig. 6 Fig. 7
Wind the mains cable to the cable winder without any play.
1
MOB00622
1
NOTE