3.5 Drawing hot water
Risk of burns!
The nozzle becomes very hot. Take hold of the nozzle by
the plastic part only.
► Connect the steam nozzle
to the adapter (A) on the
steam pipe and lock the
nozzle by rotating it.
► Place a glass or a cup
under the steam nozzle.
► Press “hot water” button
(g).
Hot water runs out of the steam
nozzle. The hot water temperature
is at least 72 °C.
► To stop drawing hot water,
press the “hot water” button
(g) again.
Wait is displayed briefly and switches back to Ready after a cooling-
down phase.
3.6 Drawing steam
Risk of scalding!
Steam is very hot. It may cause liquid to splash.
► Screw the steam nozzle
onto the adapter (A) on the
steam pipe
► Press the steam button
(h).
The thermal block is heated to
steam temperature (~140 °C).
The display flashes alternately
between Steam and Wait.
As soon as the display flashes
alternately between Steam and
Ready, steam can be drawn.
► Insert the steam nozzle
deep into the liquid but do
not touch the bottom of the
vessel.
► Press the steam button (h) to start drawing steam.
► To stop drawing steam, press the steam button (h) again.
The appliance automatically cools down after approx. 2 minutes.
Then the appliance is ready to use.
58300000116013_en_a – 21.08.06 Seite 10 von 61
To Next Page
Loading...
