6.5 Installing the water tank holder
6.5.1 Step 1: Inserting the tank coupling and centring
1.
Connect silicone hose 5.0 mm x 2.0 mm x 200 mm to the tank
coupling.
Ensure that the hose is connected to the correct con-
nection spigot. Note direction of arrow!
2.
Lock tank coupling in support housing. Ensure that the catches
(9) are engaged securely.
3.
Guide the hose through the opening in the inner support (8)
and push the inner support in the support housing.
4.
Screw the inner support to the support housing with 2 screws
(7), Torx T10 3.0 x 12.
Observe tightening torque of the screws!
0.5 Nm – 0.9 Nm.
5.
Connect centring (6) to the support housing, ensuring that the
two catches engage with the holders.
58300000116013_en_a – 21.08.06 Seite 41 von 61
To Next Page
Loading...
