6.4.2 Step 2: Detaching the mains switch holder
1.
Loosen screw (4), Torx T10.
2.
Pull mains switch holder downwards out of the support housing.
3.
To continue removing the water tank holder, loosen the screw
(5), Torx T10.
6.4.3 Step 3: Detaching the centring and tank coupling
1.
Loosen screw (5), Torx T10.
2.
Using a slotted screwdriver, release centring (6) from the two
catches and remove upwards.
3.
Loosen screws (7), Torx T10, and remove inner support (8)
downwards.
4.
Release 3 catches (9) on tank coupling and pull tank coupling
out of the guide.
58300000116013_en_a – 21.08.06 Seite 40 von 61
To Next Page
Loading...
