4.5 Hot water / steam nozzle
Attachment nozzle which is
connected to the steam pipe, for
drawing hot water and for
drawing steam to heat drinks in a
receptacle.
Hot water production for
preparation of hot drinks.
Connect nozzle to the adapter on
the steam pipe and screw on.
The steam flows through the
steam pipe (A) and the connected
steam nozzle and generates
a
vacuum inside the steam nozzle.
This vacuum is compensated by
fresh air which flows in through
the openings (B) in the nozzle
holder and (C) in the nozzle body.
If the nozzle is immersed in cold
milk above the side opening (C)
and steam is drawn, fresh air
flows in through the opening (B)
in the nozzle holder. In addition
milk is drawn in through the
opening (C) into this air flow, is
swirled with the steam flow and
dispensed again at the tip of the
steam nozzle.
The resulting circuit consisting of
drawn in, swirled and redispensed
milk heats up continuously and
provides the milk with an
increasing proportion of air
bubbles. This proportion of froth
increases the volume by up to
100%.
58300000116013_en_a – 21.08.06 Seite 26 von 61
To Next Page
Loading...
