Siemens Nespresso TK911 - Replacing the Display Unit

6.2 Replacing the display unit
The display unit is supplied pre-assembled with connecting cables as
a spare part in the housing.
Tools:
► Screwdriver bit for oval head screws
Mat. no.: 34 1021
► Torx screwdriver T10
Procedure:
1.
Remove water tank.
2.
Remove screw (1), M3.0 x 8 oval head.
Rotate cup heater anti-clockwise (2) and remove upwards.
Pay attention to protective conductor connections.
3.
Remove 4 screws (3), M3.0 x 12 Torx T10.
4.
Disconnect 2 plug-in connectors (4) and remove display unit
(5) upwards.
Installation is in reverse sequence.
During assembly, ensure that the protective conductor
wires are not wedged in.
58300000116013_en_a – 21.08.06 Seite 37 von 61