Siemens Nespresso TK911 - Page 36

6.1.2 Step 2: Loosen aluminium profiles
1.
Remove 3 screws (1), M3.0x16 Torx T10, from the protective
conductor.
2.
Remove 6 screws (2), M3.0 x 20 oval head.
3.
Remove 2 screws (3), M3.0x12 Torx T10.
4.
Remove 3 screws (4), M3.0x12 Torx T10.
5.
Remove control panel support upwards.
6.
Remove screws M3.0 x 20 oval head from base plate.
(5) for left aluminium profile
(6) for rear aluminium profile
(7) for right aluminium profile
7.
Remove aluminium profiles upwards.
58300000116013_en_a – 21.08.06 Seite 36 von 61