3.4 Preparing coffee
To ensure a successful coffee, prewarm the cups on the cup heater or
fill the cups with hot water and rinse out.
The appliance must be switched
on and ready to use.
Ready is displayed.
► If the window is closed,
open by moving hand in
front of the window.
► Insert NESPRESSO®
c
apsule with the mem-
brane face down into the
capsule infeed.
► Place a prewarmed cup
under the coffee outlet.
► Press “on” button
(e)
or
(f)
.
The cup is filled. The coffee
outlet is automatically stopped
when the programmed amount of
liquid has run through.
Then Ready is displayed again.
The used capsule is automatically emptied into the capsule container.
If the “on” buttons (e) or (f) are pressed during the infeed process or
during the ejection of a capsule, this has no effect on function.
3.4.1 Preparing coffee immediately after drawing steam
If coffee is drawn immediately
after drawing steam with the “on”
button (e) or (f), the appliance
automatically cools down
beforehand. The appliance gives
off steam in intervals and only
then does coffee run out of the
coffee outlet.
3.4.2 Stopping the coffee outlet prematurely
While coffee is being drawn,
press the “on” button (e) or (f)
again:
The coffee brewing process is
stopped.
3.4.3 Additional volume of liquid
Press the “on” button (e) or (f)
again within four seconds after
the coffee has stopped running
out:
The same amount of water is
conveyed a second time through
the same capsule.
58300000116013_en_a – 21.08.06 Seite 8 von 61
To Next Page
Loading...
