6 REPAIR
6.1 General disassembly
Danger!
Before removing the appliance, pull out the mains
plug. The appliance must be isolated!
Tools:
► Screwdriver bit for oval head screws
Mat. no.: 34 1021
► Torx screwdriver T10, T20
6.1.1 Step 1: Open the appliance
Procedure:
1.
Remove water tank, drip tray and capsule container.
2.
Remove screw (1), M3.0 x 8 oval head.
Rotate cup heater anti-clockwise (2) and remove upwards.
Pay attention to protective conductor connections.
3.
Remove screw (3), Torx T20, M4.0 x 8.
4.
Disconnect plug-in connectors (4), (5) and (6). Remove upper
section of housing upwards.
58300000116013_en_a – 21.08.06 Seite 35 von 61
To Next Page
Loading...
