Siemens Nespresso TK911 - Changing Standard Settings

3.9 Changing standard settings
The appliance has been set at the factory so that coffee can be
brewed without any additional programming.
The standard settings can be changed and adjusted. For this purpose
the “Standby”, “Small cup”, “Large cup”, “Hot water” and “Steam”
buttons are assigned additional functions.
Button (a) Standby
=
Save settings
Button (e) Small cup
=
Selection button –
Button (f) Large cup
=
Selection button +
Button (g) Hot water
=
Selection button
Button (h) Steam
=
Access programming mode
The following settings can be changed:
► Displayed language
► Water hardness
► Energy-saving mode
► Cup heater
► Rinsing
► Reset
3.9.1 Programming
Before the programming can be changed, the appliance must be in
brewing mode.
Ready is displayed.
Press and hold down steam button (h) for at least three seconds. –
Programming mode is activated.
► Press the selection button (g) to select the required setting,
e.g. Hardness // Setting 3
► To change the setting, press button (e) or (f), e.g. Hardness
// Setting 2
► Press Standby button (a) once. The changed setting is saved.
Ready is displayed again.
58300000116013_en_a – 21.08.06 Seite 14 von 61