6.4 Removing the water tank holder
Tools:
► Collecting tray for water
► Slotted screwdriver 5.5 mm
► Torx screwdriver T10
6.4.1 Step 1: Detaching the water tank holder
1.
Disassemble appliance as described in the chapter “General
disassembly”.
2.
Loosen screw (1), Torx T10.
3.
Remove water supply hose (2) from the flowmeter. Provide
a collecting tray for residual water.
4.
Loosen 4 screws (3), Torx T10, on the base plate.
5.
Remove water tank holder upwards over the heater.
6.
Remove connector plug from mains switch.
58300000116013_en_a – 21.08.06 Seite 39 von 61
To Next Page
Loading...
