6.10.1 Guiding the wires on the electronics board
Guide the PTC wire up the front of the electronics and attach
with cable tie to the wires for sliding door motor, flowmeter,
encoder and reed contacts.
3
Install wires according to the following instructions:
Guide high-voltage wires between pump connection and
pressure hose and at the top through the loop of the
transformer connection.
1
Guide wires together and secure with cable tie.
4
Lay wires in guides.
5
Guide the NTC wire and neutral wire of the power cord from
behind between pump and support. Guide the NTC wire and
neutral wire through the loop of the transformer connection.
2
58300000116013_en_a – 21.08.06 Seite 49 von 61
To Next Page
Loading...
