6. Coffee preparation with capsule 9. Steam generation
► Press the steam button (h).
► Is Steam and Service displayed alternately?
► Is Steam and Ready displayed alternately?
► Press the steam button (h).
► Is steam flowing out of the steam pipe?
10. Descaling
► Place the capsule (Cosi is most suitable) with the membrane
face down in the capsule infeed.
► See chapter “Descaling cycle”
► Press “on” button (e) or (f). Is the capsule pulled in?
11. Flow rate
► Is coffee flowing out of the coffee outlet?
► See chapter “Measuring the flow rate”
► Can 2 x 100 ml +/– 10 ml of coffee be drawn within 40 – 60
seconds?
12. Pressure and leakage test
► At the end of the brewing process is the capsule emptied into
the capsule container?
► See chapter “Pressure and leakage test”
13. Temperature measurement
7. Display of fault codes
► See chapter “Temperature measurement”
► Is a fault code F1 to F10 displayed?
14. Cleaning
See chapter “Overview of fault codes”
► See chapter “Cleaning”
8. Hot water preparation
15. Checking reed contacts
► Press “hot water” button (g).
► See chapter “Checking reed contacts”
► Is the pump functioning?
► Is hot water running out of the steam pipe?
► Can 125 ml of hot water be drawn within 20 +/– 5 seconds?
58300000116013_en_a – 21.08.06 Seite 53 von 61
To Next Page
Loading...
