Enhanced phone functions
57
Step by Step
Transferring a call after a speaker call
announcement in a group
If this function has been configured (contact your ser-
vice personnel), you can use a speaker call (announce-
ment, Æ page 85) to announce a call in progress to a
group of users Æ page 48.
After a member of the group has accepted the call re-
quest, you can transfer the waiting party.
Prerequisite: You are conducting a call.
Confirm. The other party is placed on hold.
$ Press the key shown.
Select and confirm the option shown.
j Enter the group’s station number.
[ Announce the call.
When a member of the group accepts the call
Æ page 39, you are connected to this party.
\ Replace the handset.
or
Select and confirm the option shown.
Sending a trunk flash
To activate ISDN-type services and features through the
network carrier’s analog trunks or those of other com-
munications platforms (such as "consultation hold"), you
must send a signal to the trunks before dialing the ser-
vice code or telephone number.
Prerequisite: You have set up an external connection.
N Press the key shown.
Select and confirm the option shown.
j Enter the service code and/or telephone number.
Consultation?
*80=Speaker call?
Transfer?
If the connection between the two other parties is
not established within 45 seconds, the call from
the first part returns to you (recall).
*51=Trunk flash?