Siemens OpenStage 20 G User Guide

More functions/services
79
Step by Step
Using system functions from outside
DISA (direct inward system access)
If configured (contact your service personnel), you can
use an external phone like an internal station to set up
an outgoing external connection via the system. You
can also activate or deactivate the following system
functions:
• Reset services and functions,
code #0 Æ page 77
• Call forwarding, code
*
1/#1 Æ page 32
• Lock and unlock phone,
code
*
66/#66 Æ page 67
• Save your PIN,
code
*
93 Æ page 69
• Send a message,
code
*
68/#68 Æ page 71
• Leave an advisory message,
code
*
69/#69 Æ page 73
• Ringing group, code
*
81/#81 Æ page 85
• Group call, code
*
85/#85 Æ page 85
• Caller ID suppression,
code
*
86/#86 Æ page 65
• Camp-on tone, code
*
87/#87 Æ page 52
• Open door, code
*
61 Æ page 40
• Release door opener, code
*
89/#89 Æ page 41
• Control relays, code
*
90/#90 Æ page 83
• Do not disturb, code
*
97/#97 Æ page 64
• Ringer cutoff, code
*
98/#98 Æ page 63
• Dial using speed dial, code
*
7 Æ page 47
• Associated service, code
*
83 Æ page 78
Prerequisite: Your phone supports tone dialing (DTMF)
or you can switch your phone to tone dialing. The phone
is not connected to the system.
j Establish a connection to the system. Enter the station
number (contact your service personnel).
j Wait for the continuous tone (if necessary, switch
phone to tone dialing) and enter the internal number as-
signed to you and the corresponding PIN.
( Enter the code (only required if programmed in the sys-
tem).

Siemens OpenStage 20 G Specifications

General

Brand	Siemens
Model	OpenStage 20 G
Category	IP Phone
Language	English