EasyManua.ls Logo

Siemens Optipoint 420 - Advice for Users; Care of the Telephone; Troubleshooting

Siemens Optipoint 420
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Advice for users
118
Advice for users
Care of the telephone
Use either a damp cloth or an antistatic cloth to clean the telephone.
Never use a dry cloth!
If the telephone needs to be cleaned thoroughly, use a neutral, diluted,
surface-active cleaning agent. Ensure that all traces of the cleaning
agent are removed with a damp cloth (using water only!).
Never apply a cleaning agent that contains alcohol or that is liable to
harm plastic surfaces; never use an abrasive cleaning powder.
Troubleshooting
There is no response after a key has been pressed:
Check whether the key has become stuck.
No ringing tone when an incoming call is received:
Check whether you have activated the Do Not Disturb function Æ page 79.
If you have, cancel this function to receive calls again.
You cannot dial a number:
Check whether you have locked the telephone Æ page 81. If you have, un-
lock the telephone to make calls again.
The time shown on the display is not correct:
After 24 hours at the latest, the time is corrected automatically (overnight).
All other faults:
First contact the service personnel. If the fault cannot be
eliminated, Customer Service must be called in.

Table of Contents

Other manuals for Siemens Optipoint 420

Related product manuals