Siemens POLYMOBIL Plus - Replacing the Steering Caster

Replacing important components 6 - 5
Siemens AG SPR8-125.061.02 Page 5 of 8 POLYMOBIL Plus
Medical Engineering Rev. 01 01.00 TD SD 24
Replacing the steering caster 6
• Install in the reverse sequence.
• Test the pedal positions (Refer to Operating Instructions).
Step:
1 Loosen only Allen screws on the left and right (2.5 mm wrench.
2 Pull back hexagonal shaft
3 Remove pedal
4 Remove Allen screws (wrench size 6 mm).
5 Pull out the caster.
6 Align the threaded holes on the new caster.
Fig. 8