PROGRAMMING | 101
(1) Syntax
Activation of a tool offset data record:
D<number>
Activate the tool radius compensation:
G41 ...
G42 ...
Deactivation of the tool offsets:
D0
G40
D: Command for the activation of an offset data record for the active tool. The tool
length compensation is applied with the first programmed traverse of the associated
length compensation axis.
<number>: The tool offset data record to be activated is specified via the <number>
parameter.
D0: Command for the deactivation of the offset data record for the active tool
G41: Command for the activation of the tool radius compensation with machining
direction left of the contour
G42: Command for the activation of the tool radius compensation with machining
direction right of the contour
G40: Command for the deactivation of the tool radius compensation
Example
N10 T1 D1 ; Load tool T1 and activate tool offset data record D1 of T1.
N11 G0 X... Z... ; The tool length compensations are applied.
N50 T4 D2 ; Load tool T4 and activate tool offset data record D2 of T4.
...
N70 G0 Z... D1 ; Activate other cutting edge D1 for tool T4.
To Next Page
Loading...
