OPERATION | 69
(4) Restrictions in case that quick tool presetter is downed
In case that quick tool presetter is downed, restrictions in machine operation will be
occurred as follows.
- Cannot rotate spindle.
- Cannot do manual reference point return and rapid traverse of axis.
- Feedrate of axis jog will be limited by 10mm/min.
10.2 Manual type quick tool presetter operation
(1) Operation method
Operator must install arm of quick tool presetter and use it.
However, in case of operation as follows, alarm will occur.
- In case of starting automatic operation when the arm is installed or being installed
arm during automatic operation.
- In case of installing arm during spindle rotating in manual mode.
(2) Restrictions in case that quick tool presetter is installed
Restrictions in case that quick tool presetter is installed are same as automatic type
generally.
To Next Page
Loading...
Need help?
General
